ADVANCED FUNCTIONS
NOTE: Use caution when programming complicated activities. It isn’t possible to program a pause or delay before sending commands after Power On, and the component may not be ready to respond to commands immediately after powering on.
To program, or “record” an activity, follow these steps:
1.To enter Program mode, simultaneously press and hold the Activity Button and the Alphanumeric Key or AVR Power On or Off Button to which the activity will be assigned.
2.Press the Source Selector (or Setup Button) for each device before you enter individual commands. This step counts as one of the 19 commands allowed for each activity.
3.For Power On, press the AVR or Device Power On Button.
4.Press the AVR or Device Power Off Button for Power Off.
5.Press the Activity Button to end the programming process, and the last Source Selector (or the Setup Button) will flash three times.
It isn’t possible to “edit” a command within an activity. To erase the activity:
1.Press and hold the Activity Button and the Alphanumeric Key or AVR Power On or Off Button until the Source Selector or Setup Button lights.
2.Press the Activity Button to erase the activity.
To execute an activity, press the Activity Button, then press the Alphanumeric Key (or the AVR Power On or Off Button) for the Activity.
Resetting the Remote
To reset the remote to its factory defaults, simultaneously press and hold the TV Source Selector and the “0” Alphanumeric Key. When the TV Button relights, enter the code “333”. When the TV Button goes out, and all of the Source Selectors flash, the remote control will be reset.
PROCESSOR RESET
If the unit behaves erratically after a power surge, first turn off the Main Power Switch and unplug the AC power cord for at least 3 minutes. Plug the cord back in and turn the receiver on. If this doesn’t help, reset the AVR.
NOTE: A system reset erases all user configurations, includ- ing video resolution, speaker and level settings, and tuner presets. After a reset, reenter all of these settings from your notes in the appendix worksheets.
To reset the AVR 2600, place it in Standby mode (press the front- panel Standby/On Switch so that the Power Indicator turns amber). Then press and hold the
If the receiver does not function correctly ofter a processor reset, contact an authorized Harman Kardon service center for assistance. Authorized service centers may be located by visiting the Web site at www.harmankardon.com.
NOTE: After performing a system reset, wait at least 1 minute before pressing any Source Selectors.
MEMORY
If the AVR 2600 is unplugged or experiences a power outage, it will retain user settings for up to four weeks.
44