Harman AVR 2600 owner manual Troubleshooting Guide, Symptom, Cause, Solution

TROUBLESHOOTING GUIDE

Symptom	Cause	Solution
Unit does not function when Main	• No AC Power	• Make certain AC power cord is plugged into a live outlet
Power Switch is turned on		• Check whether outlet is switch-controlled
Display lights, but no sound	• Intermittent input connections	• Secure all input and speaker connections
or picture	• Mute is on	• Press Mute Button
	• Volume control is down	• Turn up volume control
No sound from any speaker;	• Amplifier is in protection mode	• Check speaker wires for shorts at receiver and speaker ends
PROTECT message appears on	due to possible short
front panel	• Amplifier is in protection mode	• Contact your local Harman Kardon service center
	due to internal problems
No sound from surround or	• Incorrect surround mode	• Select a mode other than Stereo
center speakers	• Input is monaural	• There is no surround information from mono sources
	• Incorrect configuration	• Check speaker configuration
	• Stereo or Mono program material	• The surround decoder may not create center- or rear-channel
		information from nonencoded programs
Unit does not respond to	• Weak batteries in remote	• Change remote batteries
remote commands	• Wrong device selected	• Press the Setup Button
	• Remote sensor is obscured	• Make certain front-panel sensor is in line of sight of remote
		or connect an optional remote sensor
Intermittent buzzing in tuner	• Local interference	• Move unit or antenna away from computers, fluorescent
		lights, motors or other electrical appliances
Surround Back Speaker settings	• Multizone system has been turned	• Use the menu system to access the Zone 2 menu. Turn off the Status
cannot be accessed, and test tone	on, and the surround back channels	setting to reassign the surround back channels to the main room.
does not play through Surround	were reassigned to multizone
Back Speakers	operation
The SIRIUS Preview Channel (001)	• SIRIUS tuner is not plugged in	• Use a SIRIUS tuner module designed for use with SIRIUS Ready home
is silent		audio equipment, and plug the module into the SIRIUS Radio Jack
	• SIRIUS tuner is not located in such	• The SIRIUS tuner module needs an unobstructed view of the southern
	a way as to enable reception	sky, or to be within range of a SIRIUS terrestrial repeater; if necessary,
		purchase an extension cable from your SIRIUS Radio dealer
	• SIRIUS signal requires a refresh	• Visit www.siriusradio.com
Unable to activate Program mode	• Source Selector not held for at	• The selector will light as you initially press it, and go dark as you
on remote	least 3 seconds	hold it down. Continue to hold it and wait 3 seconds for the selector
		to light again
Remote buttons light, but AVR does	• Remote is in Zone 2 mode	• Slide the Zone Switch at the bottom of the remote to the
not respond		Zone 1 position

Additional information on troubleshooting possible problems with your AVR 2600, or installation-related issues, may be found in the list of “Frequently Asked Questions”, which is located in the Product Support section at www.harmankardon.com.

45