Envision Peripherals EN-5200E user manual Before You Operate the Monitor EN-5200e

Page 8

Before You Operate the Monitor EN-5200e

Preparing To Install An Optional Wall Mounting Arm (Not Supplied)

This monitor can be attached to a wall mounting arm you can purchase separately. Disconnect power before performing this procedure. Follow these step.

1.Pull the screw covers off the back of the monitor.

2.Support the base and remove the screws.

3.Remove the base.

4.Follow the manufacturer’s instructions to assemble the wall mounting arm. See next page for further installation instructions.

EN-5200e

8

31MY02

Image 8

Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautions General Notes Using the Right Power CordSpecial Notes on LCD Monitors Before You Operate the Monitor EN-5200e Installing & Removing the Base General FeaturesPackage Contents Connecting the Wires Using the Power Cord Supplied Adjusting the Viewing Angle Before You Operate the MonitorBefore You Operate the Monitor EN-5200e Nstall An Optional Wall Mounting Arm Not Supplied Operating Instructions Front Panel ButtonsAdjusting the OSD Settings Plug & Play DDC1/2B Feature How to Install INF & ICM FileTechnical Support FAQ Problem Possible SolutionError Message Possible Solution Resolution Chart Resolution Vertical Pixels FrequencySpecifications AppendixEN-5200eOptimal Viewing Mode 1024 x 768 x 60 Hz Factory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number DescriptionLimited 3-Year Warranty Warranty