Envision Peripherals EN-5200E user manual Nstall An Optional Wall Mounting Arm Not Supplied

Page 9

Before You Operate the Monitor

EN-5200e

nstall An Optional Wall Mounting Arm (Not Supplied)

Follow these steps to finish installing the wall mounting arm:

1.Place the wall mounting arm onto the back of the monitor. Line up the holes of the arm with the holes in the back of the monitor.

2.Insert the 4 screws into the holes and tighten.

3.Insert the power cable into the slot on the back of the monitor.

NOTE: The Envision EN-5200e is compatible with the Ergotron line of mounting and arm solutions. Visit their website at www.ergotron.com for more information on the many ways on which you can mount your AOC LCD monitor.

EN-5200e

9

31MY02

Image 9
Contents Inch TFT LCD Monitor User’s ManualFCC Statement For Your SafetyPrecautions Using the Right Power Cord Special Notes on LCD MonitorsGeneral Notes Installing & Removing the Base General Features Package ContentsBefore You Operate the Monitor EN-5200e Connecting the Wires Using the Power Cord Supplied Before You Operate the Monitor Adjusting the Viewing AngleBefore You Operate the Monitor EN-5200e Nstall An Optional Wall Mounting Arm Not Supplied Front Panel Buttons Operating InstructionsAdjusting the OSD Settings How to Install INF & ICM File Plug & Play DDC1/2B FeatureProblem Possible Solution Technical Support FAQError Message Possible Solution Resolution Vertical Pixels Frequency Resolution ChartAppendixEN-5200e SpecificationsOptimal Viewing Mode 1024 x 768 x 60 Hz Standard Resolution Horizontal Vertical Pixels Frequency Factory Preset Timing TablePin Number Description Connector Pin AssignmentLimited 3-Year Warranty Warranty