Envision Peripherals EN-5200e/ei Connecting the Wires Using the Power Cord Supplied EN-5200e

Page 6

Before You Operate the Monitor EN-5200e/ei

Connecting the Wires Using the Power Cord Supplied (EN-5200e)

1.Connect the built-in video cable into the 15-pin connector on the back of your computer and tighten the two screws.

2.Connect the power cord into your LCD monitor's Power Adapter.

3.Connect the Power Adapter to your monitor.

4.Plug the other end of the power cord into a grounded AC outlet or UL-approved power strip.

Caution: Make sure the power cord is the correct type that is required in your area. This LCD monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage areas (no user adjustment is required).

If the AC outlet is not grounded (with three holes), install the proper grounding adapter (not supplied).

EN-5200e/ei

6

29JUL02

Image 6

Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautions Using the Right Power Cord Special Notes on LCD MonitorsGeneral Notes Installing & Removing the Base General Features Package ContentsBefore You Operate the Monitor EN-5200e/ei Connecting the Wires Using the Power Cord Supplied EN-5200e Connecting the Wires Using the Power Cord Supplied EN-5200ei Adjusting the Viewing Angle Before You Operate the MonitorBefore You Operate the Monitor EN-5200e/ei Nstall An Optional Wall Mounting Arm Not Supplied Operating Instructions Front Panel ButtonsAdjusting the OSD Settings Plug & Play DDC1/2B Feature How to Install INF & ICM FileTechnical Support FAQ Problem Possible SolutionError Message Possible Solution Resolution Chart Resolution Vertical Pixels FrequencySpecifications AppendixEN-5200e/eiOptimal Viewing Mode 1024 x 768 x 60 Hz AppendixFactory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number Description