Envision Peripherals user manual Before You Operate the Monitor EN-5200e/ei

Page 9

Before You Operate the Monitor EN-5200e/ei

Preparing To Install An Optional Wall Mounting Arm (Not Supplied)

This monitor can be attached to a wall mounting arm you can purchase separately. Disconnect power before performing this procedure. Follow these step.

1.Pull the screw covers off the back of the monitor.

2.Support the base and remove the screws.

3.Remove the base.

4.Follow the manufacturer’s instructions to assemble the wall mounting arm. See next page for further installation instructions.

EN-5200e/ei

9

29JUL02

Image 9
Contents Inch TFT LCD Monitor User’s ManualFCC Statement For Your SafetyPrecautions Using the Right Power Cord Special Notes on LCD MonitorsGeneral Notes Installing & Removing the Base General Features Package ContentsBefore You Operate the Monitor EN-5200e/ei Connecting the Wires Using the Power Cord Supplied EN-5200e Connecting the Wires Using the Power Cord Supplied EN-5200ei Before You Operate the Monitor Adjusting the Viewing AngleBefore You Operate the Monitor EN-5200e/ei Nstall An Optional Wall Mounting Arm Not Supplied Front Panel Buttons Operating InstructionsAdjusting the OSD Settings How to Install INF & ICM File Plug & Play DDC1/2B FeatureProblem Possible Solution Technical Support FAQError Message Possible Solution Resolution Vertical Pixels Frequency Resolution ChartAppendixEN-5200e/ei SpecificationsAppendix Optimal Viewing Mode 1024 x 768 x 60 HzStandard Resolution Horizontal Vertical Pixels Frequency Factory Preset Timing TablePin Number Description Connector Pin Assignment