Directed Video VDC301 manual Temporary Battery Connection, Permanent Battery Connection

TEMPORARY BATTERY CONNECTION

To make a direct connection, follow these steps:

CAUTION: THE ALLIGATOR CLAMPS COULD COME LOOSE WHILE DRIVING CAUSING POSSIBLE MECHANICAL/ELECTRICAL DAMAGE.

Convert the 12-volt car cord into a hard wired connection, by con- necting a cigarette lighter socket to alligator clamps (not supplied) for temporary use (do not leave alligator clamps on when the vehicle is being driven).

Then, make a good connection to the power source terminals using alligator clips. Connect the Red clip to the Positive (+) terminal and the Black clip to the Negative (-) terminal.

PERMANENT BATTERY CONNECTION

For a permanent connection, use ring terminals of the appropriate size (one colored RED and one BLACK) (not supplied) in place of the alli- gator clamps. Observing correct polarity, connect the terminals to the battery termination posts.

A20 amp ATC fuse can be used in place of the 10 amp ATC fuse (not supplied) to increase the wattage available from the inverter.

© 2006 Directed Electronics - all rights reserved 15