Directed Video VDC301 manual Installation of rubber mounting feet

Page 10

Installation of rubber mounting feet

1.Locate plastic bag containing 4 rubber mounting feet and 4 new screws. Remove from bag.

2.Remove bottom most end cap screws from inverter housing, 2 from each side. See pictures for reference. Discard old screws.

Remove both these screws

10

© 2006 Directed Electronics - all rights reserved

Image 10
Contents With Game Plate Table of Contents Troubleshooting Non-Transferable Limited Consumer Warranty Directed Electronics all rights reserved Directed Electronics all rights reserved What’s Included Principle of OperationInverter Output Waveform Power Source Installation of rubber mounting feet Remove both these screws Placement of Inverter Connecting to Power Source Electrical Connections Temporary Battery Connection Permanent Battery ConnectionConnection to Load Directed Electronics all rights reserved Game Plate Installation Mounting the Game PlateFuse Replacement Typical Connection DiagramOperating Tips Rated Versus Actual Current Draw of EquipmentBattery Operating Time Directed Electronics all rights reserved Troubleshooting Automatic Protective Features of the InverterCommon Problems Buzz in audio systemsTroubleshooting Guide Problem Lack of Power OutputSuggested remedy Problem LOW Output Voltage Problem LOW Battery Alarm on ALL the TimeSpecifications X 4.1 W x 2.2 HDirected Electronics all rights reserved Company behind this system is Directed Electronics