Directed Video VDC301 manual Troubleshooting Guide, Problem Lack of Power Output

Page 25

a)Position the Inverter as far as possible from the television, the antenna and the antenna cables.

b)Adjust the orientation of the Inverter, the antenna cables, and the TV power cord to minimize interference.

c)Make sure that the antenna feeding the television provides an adequate ("snow free") signal and that high quality, shielded antenna cable is used.

Troubleshooting Guide

PROBLEM: LACK OF POWER OUTPUT

Possible causes

Inverter not adequately warmed up

Automotive system requires ignition to be on

Battery voltage below 9.5 volts

Equipment being operated draws too much power

Inverter in thermal shutdown condition

© 2006 Directed Electronics - all rights reserved

25

Image 25
Contents With Game Plate Table of Contents Troubleshooting Non-Transferable Limited Consumer Warranty Directed Electronics all rights reserved Directed Electronics all rights reserved Principle of Operation What’s IncludedInverter Output Waveform Power Source Installation of rubber mounting feet Remove both these screws Placement of Inverter Connecting to Power Source Electrical Connections Permanent Battery Connection Temporary Battery ConnectionConnection to Load Directed Electronics all rights reserved Mounting the Game Plate Game Plate InstallationTypical Connection Diagram Fuse ReplacementRated Versus Actual Current Draw of Equipment Operating TipsBattery Operating Time Directed Electronics all rights reserved Automatic Protective Features of the Inverter TroubleshootingBuzz in audio systems Common ProblemsProblem Lack of Power Output Troubleshooting GuideSuggested remedy Problem LOW Battery Alarm on ALL the Time Problem LOW Output VoltageX 4.1 W x 2.2 H SpecificationsDirected Electronics all rights reserved Company behind this system is Directed Electronics