Directed Electronics HON-SC1 manual Operating the system, SAT radio selection, Operation

Page 15

Operating the system

SAT radio selection

Press the SAT button to access the Sirius interface. On some radios this button may be labeled as XM or CD/SAT. Pressing this button repeatedly will cycle through sources.

Operation

Use the category control buttons to change a category, if desired.

Use the channel control buttons to change channels. Consecutive presses engage the channel browse mode allowing preview of a channel without tuning. Once the tune button is disengaged channel selection takes place.

Press and hold one of the preset buttons until a beep is heard to save a preset.

To listen to a preset station simply press the desired preset button.

When CATEGORY tune mode is selected the button will cycle through channels only within the current category. The SCAN button previews a station for a few seconds be- fore changing channel to another. Once the desired station is reached press the SCAN again.

Advisory message

“No tuner” - displayed when connection to Sirius tuner or Sirius dock is bad, no tuner is connected or if vehicle ACC power is not cycled once after connecting the

Honda/AcuraDesktop DockingSIRIUS InterfaceStation

interface.

“Connecting” - displayed during the initialization of the Sirius tuner.

“Antenna Error” - displayed when the antenna connection is not detected.

“Acquiring Signal” - displayed while acquiring digital audio stream or when the received signal drops below mini- mum required for tuner to operate.

“Unsubsc. Channel” - displayed when the selected channel is no longer subscribed

“Subscrip. Updated” - displayed when a subscription update received

“Invalid Channel” - indicates that a program became un- available after an update

“Updating XX/100” - indicates Sirius channel map update in progress

“Firmware Update” - indicates an over the air firmware update of the tuner

“Radio id” - on CH000 - shows the Sirius ESN needed for subscription services

The 12 digit Sirius ID is shown alternating: the first 6 digit is followed by a “-”, the last 6 digit is preceded by a “-”

Portable receivers

You may connect or disconnect portable receivers at any time. Upon connection the “docked portable ” message will replace the “No tuner” followed by “Acquiring Signal” before content becomes available.

© Directed Electronics, all rights reserved.

15

Image 15
Contents HON-SC1 Installation GuideFCC Notice Table of Contents Directed Electronics, all rights reserved Honda/AcuraDesktop DockingSIRIUS InterfaceStation Congratulations Package Contents Make Model Year CompatibilityHeadunit Display Capability FeaturesText Scrolling Configuration Dip Switch SettingsHonda/AcuraDesktop DockingSIRIUS InterfaceStation Installation XM1-1 CH-001 Connections When using Sirius Universal Vehicle TunerXM1-1 Connections When using Sirius SC-VDOC1Mounting Instructions Activating Your Dock & Play or Portable Sirius Radio Activating Your Installed Sirius TunerAdvisory message Operating the systemSAT radio selection Operation1153 Desktop Docking Station Problem Probable Solutions Troubleshooting guideLimited One Year Consumer Warranty HON-SC1