Dell MCQH29-XDR user manual Removing a Cable from the Card, Connector Orientation

Page 22

Rev 1.0

Cables and Modules

Figure 13: Connector Orientation

1 80 o

5.1.2Removing a Cable from the Card

1.Pull on the latch release mechanism thereby unlatching the connector and pull the connector out of the cage.

2.Do not apply torque to the connector when removing it from the card.

3.Remove any cable supports that were used to support the cable’s weight.

22

Mellanox Technologies

Image 22

Contents ConnectX-2 Dual Port I/O Card for Dell C6100 Document Number Table of Contents List of Figures List of Tables Revision History Revision History TableOnline Resources Intended AudienceRelated Documentation Document ConventionsI/O Card OverviewConnectX-2 I/O Card Details Finding the GUID/MAC and Serial Number on the Adapter Cards Card Product LabelsInfiniBand Interface O Card InterfacesI/O Interfaces Ethernet InterfaceMemory LED AssignmentPCI Express Interface System MemoryFlash Jumper ConfigurationEeprom MCQH29-XDR VPDMmmymdssss Driver Software FlexBootDriver Software and Firmware Updating Card FirmwareHardware and Software Requirements O Card InstallationInstallation Kit Hardware and Software RequirementsInstallation Instructions ConnectX Dual-Port InfiniBand I/O Card Installation KitRemoving From the Server Install the Plastic Leg onto the Board Safety Warnings Installation InstructionsLightening Electrical Hazard Over TemperatureInstallation of Equipment Disposal of EquipmentCables and Modules Cable InstallationInserting a Cable into the Card Connector Orientation Removing a Cable from the CardJ6J5 EN55022 Class a Statement Class a StatementKCC Notice Republic of Korea Only Specifications ConnectX-2 MCQH29-XDR SpecificationsInfiniBand Qsfp Connector Pinout Appendix B Qsfp InterfaceQsfp Connector Male and Female Views Température excessive Instructions d’installationInstallation du matériel Orages dangers électriquesÜbertemperatur InstallationsanleitungenGeräteinstallation Bei Gewitter Elektrische Gefahr