Dell 2850 manual Redundant Power-Supply Indicator Code Update, LCD Status Messages Update

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

Redundant Power-Supply Indicator Code Update

Table 1-3 correctly identifies the redundant power-supply indicator codes. See your Installation and Troubleshooting Guide for more information about the redundant power supply.

Table 1-3.	Power-Supply Indicator Codes
Indicator		Indicator Code
Power-on		Green indicates that the power supply is operational.
Fault		Amber indicates a problem with the power supply (fan failure, voltage error,
		etc.).
Power present		Green indicates that power is present at the power supply and that the system
		is connected to a power source.

Changing the LCD Display of the System ID and Name

To change the LCD display of the system ID and name, enter the System Setup program as described in the User’s Guide and select Embedded Server Management from the main setup screen. Then, in the screen that opens, select User-Defined, and under User Defined LCD String: enter the desired system ID for Line 1 and system name for Line 2.

LCD Status Messages Update

Table 1-4 lists updates to the LCD status messages that can occur and the probable cause for each message. The LCD messages refer to events recorded in the system event log (SEL). For information on the SEL and configuring system management settings, see the systems management software documentation.

Table 1-4. LCD Status Messages

Line 1	Line 2	Causes	Corrective Actions
Message	Message

SYSTEM SYSTEM NAME	SYSTEM ID is a unique name,
ID	five characters or less, defined by
	the user.
	SYSTEM NAME is a unique
	name, 16 characters or less,
	defined by the user.
	The system ID and name display
	under the following conditions:
	• The system is powered on.
	• The power is off and active
	POST errors are displayed.

This message is for information only.

You can change the system ID and name in the System Setup program. See your User's Guide for instructions.

6

Information Update