Dell 320 specifications Removing the System-Board Shield, Replacing the System-Board Shield

Back to Contents Page

System-Board Shield

Dell™ Vostro™ 320 Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the System-Board Shield

NOTE: You may need to install Adobe® Flash® Player from Adobe.com to view the following illustrations.

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the front panel.

3.Remove the internal panel.

4.Remove the I/O cover.

5.Remove the hinged stand.

6.Remove the optical drive.

7.Remove the back cover.

8.Remove the back metal-shield.

9.Remove the screw that secures the system-board shield to the computer.

10.Rotate the computer 90-degrees.

11.Remove the screws that secure the system-board shield to the side of the computer.

12.Remove the inverter board cable from the routing on the system-board shield.

13.Lift the system-board shield from the computer.

NOTE:While installing the system-board shield, ensure that you carefully route all the cables away from the shield.

Replacing the System-Board Shield

To replace the system-board shield, perform the above steps in reverse order.

Back to Contents Page