Dell 8500 manual Display Assembly

Back to Contents Page

Display Assembly

Dell™ Inspiron™ 8500/8600 Service Manual

Display Assembly

Display Bezel

Display Panel

Display Assembly

CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: You must remove the display assembly before you remove the palm rest.

1.Follow the instructions in "Preparing to Work Inside the Computer."

2.Turn the computer over and remove the two M2.5 x 12-mm screws labeled "D" on the bottom of the computer.

3.Turn over the computer and open the display.

4.Remove the central control cover.

5.Disconnect the display cable using the pull-tab, and release the cable from the four cable-routing clips.

NOTE: When you replace the display assembly, ensure that you route the display cable under the EMI clip and cable-routing clips.

6.Lift the display out of the computer.