Dell E5450 owner manual Installing the SmartCard-Reader Board, Removing the USH Board

Page 19

Installing the SmartCard-Reader Board

1.Place the SmartCard-reader board into its slot on the palmrest.

2.Tighten the screws to secure the SmartCard-reader board to the palmrest.

3.Fix the SmartCard-reader cable and connect the SmartCard-reader cable to its connector on the USH board.

4.Install the:

a.palmrest

b.keyboard

c.keyboard trim

d.battery

e.base cover

5.Follow the procedures in After Working Inside Your Computer.

Removing the USH Board

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the:

a.base cover

b.battery

c.hard-drive assembly

d.keyboard trim

e.keyboard

f.palmrest

3.Perform the following steps to remove the USH board:

a.Disconnect all the cables from the USH board [1] [2].

b.Remove the screw that secures the USH board to the palmrest [3].

c.Remove the USH board from the palmrest [4].

19

Image 19
Contents Dell Latitude E5450 Page Before Working Inside Your Computer Working on Your ComputerTurning Off Your Computer After Working Inside Your Computer System Overview Recommended ToolsFront and Back View Removing the SD Card Installing the SD CardRemoving the Base Cover Removing the Battery Installing the Base CoverRemoving the Hard-Drive Assembly Installing the BatteryPage Installing the Hard-Drive Assembly Removing the Memory Installing the MemoryRemoving the Keyboard Trim Removing the Keyboard Installing the Keyboard TrimRemoving the Palmrest Installing the KeyboardBase cover Battery Keyboard trim Removing the SmartCard Reader Board Installing the PalmrestPage Removing the USH Board Installing the SmartCard-Reader BoardRemoving the Finger-Print Reader Board Installing the USH BoardRemoving the LED Board Installing the Finger-Print Reader BoardRemoving the Power-Connector Port Installing the LED BoardInstalling the power-connector port Removing the Wlan Card / WiGig Card Installing the Wlan Card / WiGig CardRemoving the Wwan Card Installing the Wwan CardRemoving the Display-Hinge Brackets Removing the Display Assembly Installing the Display-Hinge BracketsPage Removing the Display Bezel Installing the Display AssemblyRemoving the Display Panel Installing the Display BezelPage Removing the Display Hinges Installing the Display PanelRemoving the Camera Installing the Display HingesRemoving the eDP Cable Installing the CameraRemoving the Coin-Cell Battery Installing the eDP cableRemoving the System Board Installing the Coin-cell BatteryDisplay assembly Removing the Heatsink Assembly Installing the System BoardInstalling the Heatsink Assembly Removing the Speakers Installing the Speakers System Setup Options PS2 Video Page KEK Performance Page Post Behavior Wwan Maintenance Technical Specifications UMA USB Feature Specification Active Area Axis 99.50 mm 53.00 mm Battery Environmental Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsDevice Status Lights Battery Status Lights Contacting Dell