Dell E5450 owner manual Installing the power-connector port

Page 23

4.Disconnect the power-connector port cable from its connector [1] and remove the power- connector port from the computer [2].

Installing the power-connector port

1.Insert the power-connector port into its place on the computer.

2.Place the metal bracket on the power-connector port and tighten the screws to secure the power- connector port to the computer.

3.Route the power-connector port cable to its routing channels and connect the power-connector port cable to its connector on the system board.

4.Install the:

a.battery

b.base cover

5.Follow the procedures in After Working Inside Your Computer.

23

Image 23

Contents Dell Latitude E5450 Page Before Working Inside Your Computer Working on Your ComputerTurning Off Your Computer After Working Inside Your Computer System Overview Recommended ToolsFront and Back View Removing the Base Cover Installing the SD CardRemoving the SD Card Removing the Battery Installing the Base CoverRemoving the Hard-Drive Assembly Installing the BatteryPage Installing the Hard-Drive Assembly Removing the Keyboard Trim Installing the MemoryRemoving the Memory Removing the Keyboard Installing the Keyboard TrimRemoving the Palmrest Installing the KeyboardBase cover Battery Keyboard trim Removing the SmartCard Reader Board Installing the PalmrestPage Removing the USH Board Installing the SmartCard-Reader BoardRemoving the Finger-Print Reader Board Installing the USH BoardRemoving the LED Board Installing the Finger-Print Reader BoardRemoving the Power-Connector Port Installing the LED BoardInstalling the power-connector port Removing the Wlan Card / WiGig Card Installing the Wlan Card / WiGig CardRemoving the Wwan Card Installing the Wwan CardRemoving the Display-Hinge Brackets Removing the Display Assembly Installing the Display-Hinge BracketsPage Removing the Display Bezel Installing the Display AssemblyRemoving the Display Panel Installing the Display BezelPage Removing the Display Hinges Installing the Display PanelRemoving the Camera Installing the Display HingesRemoving the eDP Cable Installing the CameraRemoving the Coin-Cell Battery Installing the eDP cableRemoving the System Board Installing the Coin-cell BatteryDisplay assembly Removing the Heatsink Assembly Installing the System BoardInstalling the Heatsink Assembly Removing the Speakers Installing the Speakers System Setup Options PS2 Video Page KEK Performance Page Post Behavior Wwan Maintenance Technical Specifications UMA USB Feature Specification Active Area Axis 99.50 mm 53.00 mm Battery Environmental Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsDevice Status Lights Battery Status Lights Contacting Dell