Marking the Rack
1.Determine where you want to place the bottom of the system.
CAUTION: If you are installing more than one system, install the first system in the lowest available position in the rack.
2.Place the
3.Align the bottom of the template with the desired bottom position of the system chassis.
4.Mark the upper and lower mounting positions on the vertical rails as shown by the
Each
5.Repeat steps 2 through 4 with the template over the back of the
Installing the System Chassis in the Rack
CAUTION: The
CAUTION: Due to the size and weight of the system, never attempt to install the system by yourself. You may want to use at least two persons to perform this installation.
1.To remove the optional bezel from the computer front panel, unlock the lock using the system key, press the tab on the right end of the bezel, and then rotate the bezel outward and to the left.
2.Temporarily hold the system chassis in the rack so that the front mounting bracket is about 12.7 mm (0.5 inch) from the
NOTE: This step and steps 3 and 4 require at least two persons to hold the sys- tem in the rack.
3.Attach the brackets to the sides of the system chassis by positioning the brackets so that the flange that fastens to the rack faces forward (see Figure
4.Secure each bracket to the chassis using two
5.Lift the system into position to the location you marked earlier. Ensure that the bottom of the system chassis is at the mark you made on the
support.dell.com | Rack Installation Guide |