Dell 1500, PowerApp 120 manual Installing the Top Cover in the Rack

5.Push the top cover onto the studs on the slide assemblies until the top cover stops (see Figure 1-16).

Ensure that the slots and studs have completely engaged.

At the front of the rack, make sure that the horizontal tab on the lower edge of the top cover’s mounting flange enters the lower hole, just beneath the bottom edge of the slide assembly (see Figure 1-16).

6.Secure the top cover to the rack’s left and right vertical rails using two 10-32 x 0.375-inch pan-head Phillips screws (see Figure 1-16).

top cover

shoulder studs

inner rail

10-32 x 0.375-inch pan-head Phillips screw (1 per mounting flange)

top cover mounting flange

bottom edge of slide assembly

Figure 1-16. Installing the Top Cover in the Rack

1-20 Rack Installation Guide