Dell E6400 ATG manual Removing the Fan, Replacing the Fan

Back to Contents Page

Fan

Dell™ Latitude™ E6400 and E6400 ATG and

Mobile Workstation Precision™ M2400 Service Manual

Removing the Fan

Replacing the Fan

Removing the Fan

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.

1.Follow the instructions in Before Working on Your Computer.

2.Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).

3.Remove the two M2.5 x 5-mm screws that secure the fan to the processor heatsink assembly.

4.Disconnect the fan cable from the system board.

5.Lift the fan up at a 45-degree angle, and pull it away from the flap on the processor heatsink assembly to remove it.

1	fan	2	M2.5 x 5-mm screws (2)
3	fan cable

Replacing the Fan

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.

1.Lift the flap on the heatsink assembly and insert the fan at an angle.

2.Align the screws holes in the fan with the screw holes in the processor heatsink assembly.

3.Replace the two M2.5 x 5-mm screws to secure the fan to the processor heatsink assembly.

4.Connect the fan cable to the system board.

5.Replace the bottom of the base assembly (see Removing the Bottom of the Base Assembly).

6.Follow the procedures in After Working on Your Computer.