Back to Contents Page
Display Assembly
Dell Latitude E4310 Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Display Assembly
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove the battery.
3.Remove the hinge covers.
4.Remove the mini card door.
5.Remove the LED covers.
6.Remove the keyboard.
7.Remove the screws that secure the display assembly to the computer.
8.Release the wireless local area network (WLAN) and wireless wide area network (WWAN) antenna cables from their routing guides on the computer.
9.With the display wide open, push the WLAN and WWAN cables through the opening in the system board.
10.Turn over the computer, release the WLAN, WWAN, and
11.Loosen the captive screws that secure the display cable to the computer.
12.Disconnect the display cable from its connector on the system board.
13.Lift up and remove the display assembly from the computer.
Replacing the Display Assembly
To replace the display assembly, perform the above steps in reverse order.