Back to Contents Page
LCD Assembly
Dell™ Vostro™ 1220 Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the LCD Assembly
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.
1.Follow the procedures in Before Working Inside Your Computer.
2.During installation or removal of ANY hardware, always ensure all data is backed up properly.
3.Remove the battery, hinge cover, keyboard, and optical drive from the system.
4.Disconnect the antennas from the WLAN card (if installed).
5. Unroute the antenna cables.
6.Flip the system over and open the LCD.
7.Remove the screw securing the grounding cable.
8.Disconnect the LCD cable from the system board.
9.Finish unrouting the antenna cables.
10.Remove the six screws securing the LCD assembly.