Dell 1220 specifications Removing the LCD Rails

Page 42

Back to Contents Page

LCD Rails

Dell™ Vostro™ 1220 Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the LCD Rails

NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.

1.Follow the procedures in Before Working Inside Your Computer.

2.During installation or removal of ANY hardware, always ensure all data is backed up properly.

3.Remove the battery, hinge cover, keyboard, optical drive, LCD assembly, LCD bezel and LCD panel from the system.

4.Remove the two screws from one of the LCD rails.

5.Remove the LCD rail away from the LCD panel.

6.Turn the LCD panel around.

7.Remove the two screws from the other LCD rail.

8.Remove the remaining LCD rail away from the LCD panel.

Image 42
Contents Page System Setup Entering System SetupF12 Boot Menu Device Status LEDs DiagnosticsLED Error Codes Keyboard Status LEDsReseat the LCD cable Adding and Replacing Parts Specifications Graphics Integrated BatteryAudio KeyboardAC Adapter Touch PadFingerprint Reader optional PhysicalBack to Contents Battery Removing the BatteryAccess Panel Removing the Access PanelMemory Removing the MemoryWlan Card Removing the Wlan CardCoin-Cell Battery Removing the Coin-Cell BatteryHinge Cover Removing the Hinge CoverBack to Contents Keyboard Removing the KeyboardBack to Contents Media Bay Device Removing the Media Bay DeviceLCD Assembly Removing the LCD AssemblyLift the LCD assembly away from the system Palm Rest Removing Palm RestBack to Contents Internal Module With Bluetooth Wireless Technology Removing the Bluetooth ModuleTPM Module Removing the TPM ModuleHard Drive Removing the Hard DriveBack to Contents Panel Removing the I/O PanelFan Removing the FanPage System Board Removing the System BoardBack to Contents Heat Sink and Processor Removing the Heat Sink and ProcessorBack to Contents Modem Removing the ModemSpeaker Removing the SpeakerLCD Bezel Removing the LCD BezelLCD Inverter Removing the LCD InverterLCD Camera Removing the LCD CameraLCD Panel Removing the LCD PanelBack to Contents LCD Rails Removing the LCD RailsBack to Contents LCD Hinges Removing the LCD HingesWorking on Your Computer Before Working Inside Your ComputerTurning Off Your Computer After Working Inside Your Computer Windows XP Click Start→ Turn Off Computer→ Turn Off