e.hard drive
f.WLAN card
g.access panel
h.optical
i.battery
4.Follow the procedures in After Working Inside Your computer.
Removing the Power Connector
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove:
a.Battery
b.optical
c.access panel
d.hard drive
e.memory module
f.keyboard
g.palmrest assembly
3.Perform the following steps as shown in the illustration:
a.Disconnect the power connector from the system board [1].
b.Unroute the cable from the retention clips [2].
c.Lift the power connector from the computer [3].
Installing the Power Connector
1.Insert the power connector into its slot on the chassis and guide the cable into the retention tabs.
2.Connect the power connector cable to the system board.
33