Dell P32G owner manual Installing the Display Panel, Removing the Camera Module

Page 27

Installing the Display Panel

1.Place the camera cable on the back of the display panel.

2.Connect the display cable to its connector on the display panel.

3.Place the display panel to its original position on the display assembly.

4.Tighten the screws to secure the display panel to the display assembly.

5.Connect the camera cable to camera module.

6.Install :

a)display bezel

b)display assembly

c)display hinge cover

d)battery

e)palmrest

f)keyboard

g)access panel

7.Follow the procedures in After Working Inside Your Computer.

Removing the Camera Module

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)access panel

b)keyboard

c)palmrest

d)battery

e)display hinge cover

f)display assembly

g)display bezel

3.Disconnect the camera cable from the camera module and remove the camera module from the display assembly.

27

Image 27
Contents Regulatory Model P32G Regulatory Type P32G001 Dell Inc Contents System Setup DiagnosticsSpecifications Contacting Dell Before Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerPage Page Removing the Subscriber Identity Module SIM Card Recommended ToolsRemoving the Security Digital SD Card Installing the SIM CardInstalling the Secure Digital Card Removing the Access PanelRemoving the Coin-Cell Battery Installing the Access PanelRemoving the Wireless Local Area Network Wlan Card Installing the Wlan CardRemoving the Keyboard Installing the Coin-Cell BatteryInstalling the Memory Removing the MemoryPage Removing the Palmrest Installing the KeyboardPage Page Installing the Palmrest Removing the Battery Removing the Hard Drive Installing the BatteryInstalling the Hard Drive Removing the Display-Hinge Cover Installing the Display Hinge CoverInstalling the Display Assembly Removing the Display AssemblyRemoving the Display Bezel Removing the Display Panel Installing the Display BezelPage Page Removing the Camera Module Installing the Display PanelRemoving the Fan Installing the Camera ModuleRemoving the System Board Installing the FanPage Removing the Heat Sink Installing the System BoardRemoving the Speakers Installing the Heat SinkInstalling the Speakers Removing the Power Connector Installing the Power ConnectorRemoving the Input/Output I/O board Installing the I/O Board Page Boot Sequence Navigation KeysKeys Navigation Main System Setup OptionsAdvanced Sata ODDSata Operation Security BootPassword that you must enter to log on to your system Updating the BiosSystem and Setup Password Password Type DescriptionPress Y to save the changes. The computer reboots Page Device Status Lights Enhanced Pre-Boot System Assessment ePSA DiagnosticsBeep Description Possible Cause/Troubleshooting Steps Battery Status LightsDiagnostic Beep Codes Temporary battery failure with AC adapter presentReal-time clock power fail Cmos battery failure. Reseat Page Feature Feature DescriptionUMA HD Wled AG Number of keys Vostro 65 W Vostro Height Visit support.dell.com Contacting Dell