Dell P32G owner manual Installing the System Board, Removing the Heat Sink

Page 31

Installing the System Board

1.Connect the power connector cable to the system board.

2.Thread the hard drive cable through its routing tabs.

3.Tighten the screws to secure the system board to the computer.

4.Connect the I/O board cable to the I/O board.

5.Install :

a)fan

b)display assembly

c)display hinge cover

d)battery

e)palmrest

f)keyboard

g)access panel

6.Follow the procedures in After Working Inside Your Computer.

Removing the Heat Sink

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)access panel

b)keyboard

c)palmrest

d)display hinge cover

e)display assembly

f)fan

g)system board

3.Remove the screws that secure the heat sink to the system board.

31

Image 31

Contents Regulatory Model P32G Regulatory Type P32G001 Dell Inc Contents Diagnostics System SetupSpecifications Contacting Dell Before Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerPage Page Removing the Subscriber Identity Module SIM Card Recommended ToolsRemoving the Security Digital SD Card Installing the SIM CardInstalling the Secure Digital Card Removing the Access PanelRemoving the Coin-Cell Battery Installing the Access PanelRemoving the Wireless Local Area Network Wlan Card Installing the Wlan CardRemoving the Keyboard Installing the Coin-Cell BatteryInstalling the Memory Removing the MemoryPage Removing the Palmrest Installing the KeyboardPage Page Installing the Palmrest Removing the Battery Removing the Hard Drive Installing the BatteryInstalling the Hard Drive Removing the Display-Hinge Cover Installing the Display Hinge CoverInstalling the Display Assembly Removing the Display AssemblyRemoving the Display Bezel Removing the Display Panel Installing the Display BezelPage Page Removing the Camera Module Installing the Display PanelRemoving the Fan Installing the Camera ModuleRemoving the System Board Installing the FanPage Removing the Heat Sink Installing the System BoardRemoving the Speakers Installing the Heat SinkInstalling the Speakers Installing the Power Connector Removing the Power ConnectorRemoving the Input/Output I/O board Installing the I/O Board Page Navigation Keys Boot SequenceKeys Navigation Main System Setup OptionsAdvanced Sata ODDSata Operation Security BootPassword that you must enter to log on to your system Updating the BiosSystem and Setup Password Password Type DescriptionPress Y to save the changes. The computer reboots Page Device Status Lights Enhanced Pre-Boot System Assessment ePSA DiagnosticsBeep Description Possible Cause/Troubleshooting Steps Battery Status LightsDiagnostic Beep Codes Temporary battery failure with AC adapter presentReal-time clock power fail Cmos battery failure. Reseat Page Feature Feature DescriptionUMA HD Wled AG Number of keys Vostro 65 W Vostro Height Visit support.dell.com Contacting Dell