1 | securing clips (2 per connector) | 2 | memory module |
5. Ground yourself and install the new memory module:
NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.
a.Align the notch in the module connector with the tab in the connector slot.
b.Slide the module firmly into the slot at a
DIMM B
NOTICE: If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMMA" before you install a module in the connector labeled "DIMMB." Insert memory modules at a
1.Follow the procedures in Before You Begin.
2.Turn the computer
1 | memory module cover | 2 | captive screw |
|
|
|
|
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the
3.If you are replacing a memory module, ground yourself and remove the existing module:
a.Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
b.Remove the module from the connector.