Dell D620, PP18L manual Removing the Display Assembly

Back to Contents Page

Display Assembly

Dell™ Latitude™ D620 Service Manual

Removing the Display Assembly

Removing the Display Bezel

Removing the Display Panel

Installing the Display Panel

Removing the Display Hinges

Removing the Display Assembly

CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

1.Follow the instructions in Before Working Inside Your Computer.

2.Remove the hinge cover (see Hinge Cover).

3.Remove the keyboard (see Keyboard).

4.Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board.

5.Disconnect the antenna cable(s).

6.Carefully remove the antenna cable and the display cables from their routing guides.

7.Close the display.

8.Turn the computer upside-down with the back of the computer facing you.

9.From the bottom of the computer, remove the two M2.5 x 8-mm screws labeled "D."

10. From the back of the computer, remove the two M2.5 x 8-mm screws.

11. Turn the computer right-side up and open the display.