Removing the Battery Latch Assembly
1.Follow the instructions in “Before You Begin” on page 6.
2.Remove the system board (see “Removing the System Board” on page 99).
3.Press and push the plastic clip on the battery release latch to release it from the battery latch assembly.
4.Using a screwdriver, remove the latch spring from the hook on the battery latch assembly.
5.Lift the battery latch assembly out of the computer base.
Replacing the Battery Latch Assembly
1.Follow the instructions in “Before You Begin” on page 6.
2.Place the battery latch assembly in the channel in the computer base.
3.Push the plastic clips on the battery release latch into the hole on the battery latch assembly to secure the battery release latch.
4.Using a screwdriver, place the latch spring over the hook on the battery latch assembly.
Ensure that the newly installed latch moves smoothly and freely when pushed and released.
5.Replace the system board (see “Replacing the System Board” on page 102).
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.
CHAPTER 25: BATTERY LATCH ASSEMBLY
1
2
3
1 | battery latch assembly | 3 latch spring |
2 | clip |
|
0111/0111