Dell D630-3N28FD1, D630-2X33GF1 manual Removing the Display Hinges

1	top flex-cable	2	flex-cable release levers	3	back of display panel
	connector		(2)
4	inverter board	5	bottom flex-cable	6	pull-tab on bottom flex-cable
			connector		connector

Removing the Display Hinges

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as a connector on the back of the computer.

1.Follow the instructions in Before You Begin.

2.Remove the display assembly (see Display Assembly).

3.Remove the display bezel (see Removing the Display Bezel).

4.Remove the display panel (see Removing the Display Panel).

5.Remove the M2.5 x 5-mm screw from the right display hinge.

1 M2.5 x 5-mm screw	2 display hinges (2)	3 top cover
	(left and right)

4alignment pin

6.Lift the right display hinge off the two alignment pins and out of the top cover.

7.Repeat step 5 and step 6 for the left display hinge.

Back to Contents Page