Dell PP20L owner manual Replacing the Display Assembly, Display Bezel

1	M2.5 x 5-mm screws	4	grounding-wire	7	display cable connector on system
	(2)		screw		board
2	display cable	5	antenna cables	8	display cable channel
3	display cable pull-tab	6	standby switch

11. Lift the display up and away from the computer.

NOTICE: The standby switch is fragile and easily broken. Avoid knocking the switch when removing and replacing the display.

Replacing the Display Assembly

1.Ensure the display cable is lying flat in the display cable channel and securely tucked underneath the tabs before sliding the display onto the computer base.

NOTE: Ensure the antenna cables are not twisted and that they are lying flat in the antenna cable clip.

2.Replace the two M2.5 x 5-mm screws in the top side of the computer.

3.Connect the display cable to the system board.

4.Reroute the display cable into the cable channel.

5.Replace the two M2.5 x 8-mm screws in the back of the computer and replace the two screw covers.

6.Replace the two M2.5 x 8-mm screws in the bottom of the computer.

7.Replace the hinge cover (see Replacing the Hinge Cover).

8.If a Mini-Card is installed, connect the antenna cables to the card (see Mini-Card). If one is not installed, tuck the antenna cables into their secured location.

9.Replace the Mini-Card cover.

Display Bezel

Removing the Display Bezel

CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.