Dell PP20L owner manual Replacing the Display Bezel

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: To help prevent damage to the system board, you must remove the main battery (see Before Working Inside Your Computer) before you begin working inside the computer.

1.Follow the instructions in Before Working Inside Your Computer.

2.Remove the display assembly (see Removing the Display Assembly).

3.Remove the six rubber display bumpers.

4.Remove the six M2.5 x 4.2-mm screws around the display bezel.

1 M2.5 x 4.2-mm screws(6)

2 rubber display bumpers (6) 3 display bezel

NOTICE: Removal of the bezel from the display back cover requires extreme care to avoid damage to the bezel.

5.Use your fingers to separate the bezel from the display back cover by pulling the lower-right corner of the bezel down toward the bottom edge of the display assembly to clear the tab on the bottom of the lower-right corner. Then pull the bezel toward the right side of the display assembly to clear the tab on the side of the lower-right corner. Continue this motion until you have cleared all sides of the display bezel.

1 display bezel 2 display panel

Replacing the Display Bezel

1.Starting at any corner, use your fingers to gently snap the bezel into place to secure it to the display panel.

2.Replace the six M2.5 x 4.2-mm screws around the display bezel.

3.Replace the six rubber display bumpers around the display bezel.