Dell D410 manual Memory Module and Modem

Page 34

Back to Contents Page

Memory Module and Modem

Dell™ Latitude™ D410 Service Manual

Memory Module

Modem

Memory Module

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

NOTE: Only DDR2 memory dimms fit and can be used in this computer.

NOTE: Memory modules purchased from Dell are covered under your computer warranty.

Your computer has two user-accessible SODIMM sockets, one accessed from beneath the keyboard (DIMM A), and the other accessed from the bottom of the computer (DIMM B).

NOTE: If your computer has only one memory module, install the memory module in the connector labeled "DIMM A."

Removing the Memory Module from DIMM A

1.Follow the instructions in "Preparing to Work Inside the Computer."

2.Remove the center control cover.

3.Remove the keyboard.

NOTICE: To prevent damage to the memory module connector, do not use tools to spread the inner metal tabs that secure the memory module.

NOTICE: Handle memory modules by their edges, and do not touch the components on a module.

NOTE: If you are replacing a memory module, remove the existing module.

4.Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.

5.Remove the module from the connector.

1memory module

2securing clips (2 per connector)

NOTICE: If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM A" before you install a module in the connector labeled "DIMM B." Insert memory modules at a 45-degree angle to avoid damaging the connector.

Replacing the Memory Module in DIMM A

1. Ground yourself and install the new memory module:

Image 34
Contents January 2005 Rev. A00 Before You Begin Preparing to Work Inside the ComputerComputer Orientation Recommended ToolsScrew Identification Back to Contents Flashing the Bios Internal Card With Bluetooth Wireless Technology Replace the battery Coin-Cell Battery Removing the Coin-Cell BatteryReplacing the Coin-Cell Battery Removing the Center Control Cover Center Control CoverReplacing the Center Control Cover Display Assembly Removing the Display AssemblyReplacing the Display Assembly Back to Contents Removing the Fan FanReplacing the Fan Page Removing the Hard Drive Hard DriveReplacing the Hard Drive Page Keyboard Removing the KeyboardReplacing the Keyboard Mini PCI Card Removing the Mini PCI CardReplacing the Mini PCI Card Replace the center control cover Back to Contents Palm Rest Removing the Palm RestPage Replacing the Palm Rest USB Connector Pin Assignments for I/O ConnectorsVideo Connector Removing the Smart Card Reader Smart Card ReaderReplacing the Smart Card Reader Replace the M2 x 3-mm screw System Board Removing the System BoardReplacing the System Board Back to Contents System Components January 2005 Rev. A00 Memory Module and Modem Memory ModuleRemoving the Memory Module from Dimm B Modem Replacing the Memory Module in Dimm BRemoving the Modem Replacing the Modem
Related manuals
Manual 107 pages 60.63 Kb Manual 110 pages 17.6 Kb