2Setting Up the Monitor
Attaching the Stand
NOTE: The stand is detached when the monitor is shipped from the factory.
NOTE: This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for the set up instructions.
To attach the monitor stand:
1.Remove the cover and place the monitor on it.
2.Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
3.Press the stand till it snaps into place.
Connecting Your Monitor
WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions.
NOTE: Do not connect all cables to the computer at the same time.
To connect your monitor to the computer:
1.Turn off your computer and disconnect the power cable.
Connect the VGA/DVI/DP cable from your monitor to the computer.
Setting Up the Monitor | 21 |