Dell 170S appendix Setting Up the Monitor, Attaching the Stand, Connecting Your Monitor

Page 23

Back to Contents Page

Setting Up the Monitor

Dell™ E170S/E190S Flat Panel Monitor User's Guide

Attaching the Stand

Connecting the Monitor

Organizing Your Cables

Attaching the Soundbar (Optional)

Removing the Stand

Attaching the Stand

NOTE: Stand is detached when the monitor is shipped from the factory.

Remove the monitor cover and place the monitor on it.

1.Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.

2.Lower the stand so that the monitor mounting area snaps onto the stand.

Connecting Your Monitor

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions.

To connect your monitor to the computer perform the following steps/instructions:

1.Turn off your computer and disconnect the power cable.

2.Connect the blue (analog VGA) display connector cable to the corresponding video connector on the back of your computer.

Connecting the blue VGA cable

NOTE: The Graphics are used for the purpose of illustration only. Appearance of the the computer may vary.

After you have completed connecting the VGA cable, follow the procedure below to complete your monitor setup:

Image 23

Contents Dell E170S/E190S Flat Panel Monitor Users Guide About Your Monitor Package ContentsFront View Front panel controls Label Description Product FeaturesIdentifying Parts and Features Front View Back ViewDescription/Use Side ViewBack view Label Bottom View Monitor SpecificationsPower Management Modes Pin Assignments Flat Panel SpecificationsModel E170S/E190S ResolutionPreset Display Modes ElectricalPlug and Play Capability Physical CharacteristicsEnvironmental Caring for Your Monitor Maintenance GuidelinesLCD Monitor Quality & Pixel Policy Appendix Setting Up Your Monitor Select Advanced Operating the Monitor Using the Front PanelAuto Adjust Power ButtonIcon Menu Name and Sub- menus Description Using the On-Screen Display OSD MenuThis is used to exit out of the Main Menu Image settingsPosition Color SettingsPreset sRGB Settings LocationFactory Reset OSD Warning Messages Setting the Maximum ResolutionTilt Using the Dell Soundbar OptionalUsing the Tilt Back to Contents Setting Up Your Monitor Dell E170S/E190S Flat Panel Monitor Attaching the Stand Setting Up the MonitorConnecting Your Monitor Connecting the blue VGA cableRemoving the Stand Organizing Your CablesAttaching the Soundbar Optional Back to Contents Self-Test Solving ProblemsBuilt-in Diagnostics Common Symptoms What You Experience Possible Solutions Common ProblemsTroubleshooting the Dell Soundbar Optional Product-Specific ProblemsBack to Contents