Dell SP2008WFPF appendix Plug and Play Capability, General, Flat Panel, Webcam MIC Specifications

Page 6

1 upstream - rear

4 downstream - 2 on rear; 2 on left side

NOTE: USB 2.0 capability requires 2.0-capable computer.

NOTE: The USB interface of the monitor works ONLY when monitor is powered ON (or in Power Save Mode). Switching your monitor OFF and then ON would re-enumerate its USB interface; attached peripherals may take a few seconds to resume normal functionality.

Plug and Play Capability

You can install the monitor in any Plug and Play-compatible system. The monitor automatically provides the computer system with its Extended Display Identification Data (EDID) using Display Data Channel (DDC) protocols so the system can configure itself and optimize the monitor settings. Most monitor installations are automatic; you can select different settings, if desired.

General

Model numberSP2008WFP

Flat Panel

Screen type

Active matrix - TFT LCD

Screen dimensions

20.1 inches (20.1-inch viewable image size)

Preset display area:

 

Horizontal

433.44 mm (17.06 inches)

Vertical

270.9 mm (10.67 inches)

Pixel pitch

0.258 mm

Viewing angle

160° (vertical) typ, 160° (horizontal) typ

Luminance output

300 CD/m ²(typ)

Dynamic contrast ratio

2000 to 1 (typ)

Faceplate coating

ARC-Glare (2H)

Backlight

CCFL (4) edgelight system

Response Time

2ms typical (Grey to Grey)

 

 

Webcam - MIC Specifications

Lens

Field of view

66.5 degree +/- 5 %

 

Focus mode

Fixed Focus

 

Focus area

49cm~Infinity

 

Focusing

1100 mm

 

distance (normal

 

 

mode)

 

Image Sensor

Active array size

2.0 mega-pixel

Video specification

Video frame rate

1600 x 1200 (UXGA) - up to 10 frames per second

 

 

640 x 480 (VGA) and below - up to 30 frames per second

 

Image flip

Horizontally

 

Digital zoom

2x

Audio Specification

Microphone type

Dual Microphone

Interface

 

USB 2.0 high Speed

Power Supply

 

5.0 volts+- 5%

 

 

 

Webcam - MIC System Requirements

The following are the minimum system requirements for Webcam - MIC feature:

Intel® Pentium® 4 or AMD® equivalent processor running at 1.8 GHz or higher (Recommended: Intel Pentium 4, 2.8 GHz with Hyper-Threading enabled)

Microsoft® Windows® XP Service Pack 2 or Windows Vista

256 MB RAM (512 MB RAM or higher recommended)

580 MB free hard disk space

Image 6
Contents About Your Monitor Solving Problems Dell SP2008WFP Flat Panel MonitorAbout Your Monitor Front ViewBack View Bottom View Side ViewPin Assignments Monitor SpecificationsPower Management Modes Left side Right sidePin Number Monitor Side of the 15-pin Side Signal Cable Universal Serial Bus USB InterfaceUSB ports General Webcam MIC SpecificationsPlug and Play Capability Flat PanelPhysical Characteristics Monitor ResolutionPreset Display Modes Video Supported ModesCleaning Your Monitor EnvironmentalAppendix Visit support.dell.comSetting Up Your Monitor Setting Up Your Monitor Setting Up Your Monitor Dell SP2008WFP Flat Panel Monitor Connecting Your Monitor Using the Front Panel Read Software License Agreement and click Yes to continueVideo input select Using the OSD Menu Icon Menu Submenus Description Exit SettingsPhase Fine BrightnessSharpness Scaling RatioColor Theatre Preset Sports Preset Nature Preset Hue Saturation Response Time AdvancedInput Color Format Dynamic Horizontal PositionPage Factory Reset Setting the Optimal Resolution OSD Warning MessagesUsing the Dell Soundbar Optional Soundbar Attachment to the MonitorSolving Problems Troubleshooting Your MonitorGeneral Problems Common Symptoms Problem Description Possible SolutionsProduct Specific Problemss USB ProblemsTroubleshooting Your Soundbar Back to Contents Attaching the Stand Using Your Monitor StandUsing the Tilt Organizing Your CablesRemoving the Stand