Dell SR2320L appendix Connecting the Monitor

Page 28

Connecting the Monitor

WARNING: Before you begin any of the procedures in this section, follow the safety instructions.

To connect your monitor to the computer perform the following steps/instructions:

1.Turn off your computer and disconnect the power cable.

2.Connect the HDMI cable, white (digital DVI-D), or blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not use all the cables on the same computer. Use all of the cables only when they are connected to different computers with appropriate video systems.

Connecting the blue VGA cable

Connecting the White DVI Cable*

Connecting the HDMI Cable* (for selective models)

NOTE: *Optional purchase item. To purchase DVI or HDMI cable, please visit Dell.com

NOTE: The Graphics are used for the purpose of illustration only. Appearance of the the computer may vary.

After you have completed connecting the VGA/DVI/HDMI cable, follow the procedure below to complete your monitor setup:

1.Plug the power cables for your computer and monitor into a nearby outlet.

2.Turn on the monitor and the computer.

Image 28
Contents Dell SR2320L monitor Users Guide Package Contents About Your MonitorProduct Features Identifying Parts and Features Front ViewBack View Front View Front Panel Controls Label DescriptionSide View Bottom ViewBack View Label Description/Use Left SidePower Management Modes Monitor SpecificationsPin Assignments DVI Connector Pin Pin Side of the Connected Signal Number CableResolution Flat Panel SpecificationsModel SR2320L Preset Display Modes Physical CharacteristicsVideo Supported Modes ElectricalMaintenance Guidelines EnvironmentalPlug and Play Capability LCD Monitor Quality & Pixel PolicyBack to Contents Appendix Setting Up Your Monitor Click Change Display Settings Click Advanced Settings Using the On-Screen Display OSD Menu Using the Front PanelOperating the Monitor Main Menu for non Analog non VGA Input Brightness Contrast Back Auto Adjust Input Source Auto SelectVGA DVI-D Display Settings Page DDC/CI Factory Reset PersonalizeOSD Warning Messages Using the Dell Soundbar Optional Setting the Maximum ResolutionClick Change Display Settings Using the Tilt TiltSetting Up Your Monitor Dell SR2320L monitor Setting Up the Monitor Attaching the BaseConnecting the Monitor Attaching the Soundbar Optional Removing the Monitor StandBuilt-in Diagnostics Solving ProblemsSelf-Test Common Problems Common Symptoms What You Experience Possible SolutionsProduct-Specific Problems Troubleshooting the Dell Soundbar OptionalBack to Contents