Heat & Glo LifeStyle 7000XLT manual Wiring the Fireplace

			BLACK S2	REMOTE SWITCH
3/16” PIGGYBACK CONNECTOR
				PIGTAIL
			ON
			OFF
	WHITE T2		ON/OFF
			SWITCH
GAS VALUE	RED T1
		THERMOPILE
THERMOCOUPLE				OPTIONAL WALL SWITCH,
		BLACK S1
Figure 26. Standing Pilot Ignition Wiring Diagram				THERMOSTAT OR REMOTE

Step 8. Wiring the Fireplace

NOTE: Electrical wiring must be installed by a licensed electrician.

CAUTION: DISCONNECT REMOTE CONTROLS IF AB- SENT FOR EXTENDED TIME PERIODS. THIS WILL PRE- VENT ACCIDENTAL FIREPLACE OPERATION.

For Standing Pilot Ignition Wiring

Appliance Requirements

•This appliance DOES NOT require 110-120 VAC to operate.

!WARNING: DO NOT CONNECT 110-120 VAC TO THE GAS CONTROL VALVE OR THE AP- PLIANCE WILL MALFUNCTION AND THE VALVE WILL BE DESTROYED.

Optional Accessories

Optional fan and remote control kits require that 110-120 VAC be wired to the factory installed junction box before the fireplace is permanently installed.

Remote Wall Switch

Position the remote wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) or less length of 18 A.W.G. minimum wire and connect it to the fireplace ON/ OFF switch pigtails.

WARNING: DO NOT CONNECT 110-120 VAC ! TO THE REMOTE WALL SWITCH OR THE

CONTROL VALVE WILL BE DESTROYED.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC- TION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPERAND DANGEROUS OPERATION. VERIFY PROPER OPERATION AFTER SERVICING.

BLK

BLK

BLK

VARIABLE SPEED CONTROL

BLK

JUNCTION BOX

BLK

BLK

BLK

WHT WHT

BLK

GROUND

NOTE: IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THE APPLIANCE MUST BE REPLACED, IT MUST BE REPLACED WITH TYPE 105OC RATED WIRE.

BLOWER RECEPTACLE

TEMPERATURE

SENSOR SWITCH

GRN

BLKWHT

110-120 VAC

BLOWER

JUNCTION BOX

FAN

TEMPERATURE

SENSOR SWITCH

SPEED CONTROL

Figure 27. Fan Wiring Diagram

(RHEOSTAT)

27