connecting to a PC(VP- DX103(i)/DX104/DX105(i) only)
CONNECTING THE USB CABLE |
|
| To copy the movie fi les and photo fi les to |
|
| your PC, connect your DVD camcorder |
|
| to the PC with a USB cable. | PC |
• Do not apply excessive force when inserting or extracting a USB cable into/from a USB jack.
•Insert a USB cable after checking the direction of its insertion is correct.
•
Disconnecting the USB cable
After completing the data transmission, you must disconnect the cable in the following way:
1.Click the “Unplug or eject hardware” icon on the task tray.2.Select “USB Mass Storage Device” or “USB Disk”, then click “Stop.”
3.Click “OK.”4.Disconnect the USB cable from the DVD camcorder and PC.
•We recommend using the AC power adaptor as the power supply instead of the battery pack.
•When the USB cable is connected, turning the camcorder on or off may cause the PC to malfunction.
•If you disconnect the USB cable from the PC or the DVD camcorder while transferring, the data transmission will stop and the data may be damaged.
•If you connect the USB cable to a PC via a USB HUB or simultaneously connect the USB cable along with other USB devices, the DVD camcorder may not work properly. If this occurs, remove all USB devices from the PC and reconnect the DVD camcorder.
94_ English
连接到电脑 ( 仅限 VP-
DX103(i)/DX104/DX105(i))
连接 USB 数据线| DVD camcorder | 连接 USB 数据线至您的个人电脑，将 | |
DVD 摄像机内的影音文件和照片文件 | ||
| ||
| 复制到电脑。 |
• 在将 USB 数据线插入或拔出 USB 接口的时候不要用力 过猛。
• 请在插入 USB 端子之前检查 插入的方向是否正确。
• 推荐使用高速 USB (USB 2.0)。
断开 USB 数据线在完成传输数据之后，您必须按照以下方法断开数 据线：
1.点击任务栏上“安全删除硬件”图标。2.选择“USB Mass Storage Device”或“USB Disk,”然后点击“停止”。3.点击“确定”。4.从 DVD 摄像机和电脑上拔出 USB 数据线。•我们建议您使用交流电源适配器代替电池组为 DVD 摄像机提供 电能。
•当 USB 数据线已连接时，打开或关闭摄像机也许会导致电脑发 生故障。
•如果在转移数据的过程中从 DVD 摄像机或者电脑上断开 USB 数据线，数据传输将会停止并且数据可能损坏。
•如果您通过 USB HUB 将 USB 数据线与电脑相连或者同时连接 其他的 USB 设备，数码摄像机可能会工作不正常。如果发生这 种情况，请您从电脑上拔下 USB 设备，重新连接数码摄像机。
中文 _94