O P E R AT I O N | ENGLISH |
ENGLISH | O P E R AT I O N |
Stop Watch (continued) | Clock |
6. Press and release the ENTER button to set the |
2.Hold the radio in front of you, parallel to
2. To start the timer, push the CHANNEL SELECT |
button up. To stop the timer, push the CHANNEL |
You can set your microTALK® to display the time of day. To use the Clock function:
time and return to Clock mode. Press and |
release the MODE button to leave Clock mode. |
the ground, and turn around in a circle at least two times, then press Compass button
SELECT button up again. |
3. To restart the timer from | CHANNEL |
SELECT | |
that point, push the | button |
CHANNEL SELECT button |
|
up a third time. Or to |
|
reset the timer back to 00:oo:oo, press the ENTER button.
4.After starting the timer, you can view an interim “split” time (while the timer continues to run) by pushing the CHANNEL SELECT button down. To return to the timer, push the CHANNEL SELECT button down again.
5.Press and release the MODE button to leave
Stop Watch mode.
Press the MODE button until the current time is displayed in the LCD. To set the time of day:
1.While in Clock mode, press and release the ENTER button. The hour will begin flashing in the LCD.
2.Push the CHANNEL SELECT button up or down to set the hour.
MODE | ENTER |
button | button |
While in Clock mode, your microTALK® will alert you to incoming calls, but the LCD will continue to show the Clock display. You can also transmit as normal with the CALL button, TALK button or in VOX mode. When you do, the LCD will automatically return to normal display. Once you have finished transmitting, the unit will automatically return to Clock mode. (NOTE: You can not view the compass mode while in Clock mode.)
Compass
Your microTALK features an
again. Or you may also place the radio on the palm of one of 
your hands, parallel 
to the ground, and 
turn it in a circle at 
least two times with your other hand, then press the COMPASS button again.
3.If compass calibration was successful, “SUCCES” will appear in the LCD for
4.If “FAIL” appears in the LCD, repeat steps 1 and 2. (If you receive repeated “FAIL” messages, change locations and repeat steps 1 and 2.)
While in Stop Watch mode, your microTALK® will alert
you to incoming calls, but 
the LCD will continue to 
show the Stop Watch display. You can also transmit as normal with the CALL button, TALK button or in VOX mode; when you do, the LCD will automatically return to normal display. The timer will continue to run and can be viewed simply by returning to Stop Watch mode. (NOTE: You can not view the compass
mode while in Stop Watch mode.)
3.Press and release the ENTER button again. The minutes will begin flashing in the LCD.
4.Push the CHANNEL SELECT button up or down to set the minutes.
5.Press and release the ENTER button again. “AM” or “PM” will begin flashing in the LCD. Push the CHANNEL SELECT button up or down to set AM or PM.
recommended that you calibrate the compass before each use.) It is important to keep the radio parallel to the ground at all times while calibrating and using the compass.
Calibrating the Compass
1.Press and hold the COMPASS button for 2 seconds. “Compass” and “CALIbr” will appear in the LCD.
COMPASS button 
Using the Compass
After proper calibration (see steps
COMPASS button. “Compass” and the current direction will be displayed. The radio
must always be parallel to the ground to give accurate directional readings. The direction of the antenna is the direction displayed in the LCD. To exit Compass mode, press and release the COMPASS button again.
13 | 14 |