Model 162 PBM High Performance Subwoofer | tlantic | |
ATECHNOLOGY | ||
|
Subwoofer Troubleshooting Guide
Once your subwoofer has been set up, you should have many years of
Problem | Possible Cause | Possible Solution |
|
|
|
No bass output | AC power cord unplugged or plugged into a | Plug into a working outlet. |
|
|
|
| Input cables not securely connected or defective. | Check all connections, then try another input cable. |
|
|
|
Audible buzz | Input cable not securely connected or defective. | Check all connections, then try another input cable. |
or hum | Single HI LEVEL input connected to the RIGHT channel. | Connect to the LEFT input channel. |
| Ground loop through antenna or cable TV system input. | Test by disconnecting antenna and/or cable system input leads. |
|
| If hum goes away, install isolation balun(s) at that point. |
|
|
|
More than one | More than one source is playing. | All the subwoofer’s inputs are active at all times. Turn off |
source audible |
| unwanted source. |
|
|
|
Weak bass | Subwoofer too far from the wall. | Move the subwoofer closer to a wall or corner. |
| OUTPUT LEVEL CONTROL set too low. | Turn control up somewhat. |
|
|
|
Weak bass: vague | Input source connected to HI LEVEL inputs is wired | Check speaker wire connections and reconnect in proper |
stereo image | out of phase. | phase. |
|
|
|
9