Before Operation
Precautions When Installing the Printer
1.Prior to operation, read the safety instructions carefully and observe them.
2.Do not use or store the printer near fire, excessive moisture, in direct sunlight, near an air conditioner or heater or other source of unusually high or low temperature or humidity or excessive dust.
3.Do not place the printer where chemical reactions occur, such as in a laboratory.
4.Do not place the printer where air is mixed with salt or gas.
5.The printer must sit on a firm, level surface where there is ample ventilation. Never allow the printer's air vent to be blocked by a wall or other object.
6.Do not put anything on the top of printer.
7.Do not place the printer near a radio or television, and do not use the same wall outlet for the printer and radio or television. Radio or television reception could be adversely affected.
8.Do not use a power voltage or frequency other than those specified.
9.Do not put anything on the power cord or step on it.
10.Do not drag or carry the printer with the power cord or interface cable.
11.Avoid plugging the power cord into an outlet with many loads.
12.Do not bundle the power cord when inserting the plug.
13.Always grip the plug housing, not the cord, to plug/unplug the power cord.
14.Make certain the power is turned off before connecting/disconnecting the interface cable.
15.Avoid lengthening the signal cable or connecting it to any
16.Place the printer near the outlet where the power cord can be unplugged easily to shut off power.
17.Use the AC outlet that accepts a
8