BSS Audio MC-1 manual Installation, Set the 6-position switch, Default setting

Page 2

Installation

Set the 6-position switch

The 6-position switch is located on the side of the media converter.

Use a small flat blade screwdriver to set the recessed switches.

All switches are shown in the default position, UP.

1.Remote Fiber Fault Detect

2.Pause (symmetric)

3.Pause (asymmetric)

4.Transparent Link Pass-Through

5.Auto-Negotiation 6. Loop Back

Note: Switch positions S2 and S3 work together to configure the media converter for Pause conditions.

S1 Remote-Fault Detection

up Disabled

down Enable

S2 & S3 work in combination

 

Pause

 

 

10 sw position 2 up and 3 down:

Symmetric

01 sw position 2 down and 3 up:

Asymmetric

11 sw positions 2 and 3 up:

Pause is OFF (default position)

00 sw positions 2 and 3 down:

Symmetric and Asymmetric

S4 Transparent Link Pass-Through

 

up

Enable Link Pass-Through

down

Disable Link Pass-Through

S5 Fiber Auto-Negotiation

 

up

Disable Fiber Auto-Negotiation for the fiber link

 

(default setting)

 

down

Enable Fiber Auto-Negotiation for the fiber link

S6 Loop Back

Disable RX/TX signal loop back (default setting)

up

down

Enable RX/TX signal loop back

2

BSS Audio 800-931-2357 8760 South Sandy Parkway, Sandy, Utah 84070

www.bssaudio.com 800-931-2357

3

Image 2
Contents 100 m 328 ft 10 km 6.2 miles BSS Audio MC-1MC-1 Default setting InstallationSet the 6-position switch Install the fiber cable Install ModeOperation Cable Specifications Technical Specifications 25 x 0.1 x 4.8 82mm x 25mm x 122mmTechnical support Address TroubleshootingContact Us European regulations Compliance InformationCE Mark FCC regulations Canadian regulations AchtungTrademark notice Copyright restrictions