Aspire Digital M1610, M261 manual Jumper Settings, Setting Jumpers

Jumper Settings

This section explains how to set jumpers for correct configuration of the mainboard.

Setting Jumpers

Use the motherboard jumpers to set system configuration options. Jumpers with more than one pin are numbered. When setting the jumpers, ensure that the jumper caps are placed on the correct pins.

System Board Jumper Setting

Features		Default setting	Remark (color and
				other)
On-board Jumper and	CLR_CMOS(PIN2_3)1	2-3 : Normal (Default)	1-2	: Clear CMOS
default setting (See Pin	& default setting		2-3	: Normal (Default)
definition for the detail)

System Board Header Setting

Front Panel

Illustration	Pin	Signal Name	Description
	1	5V_SYS	Hard disk LED pull-up(330 ohm) to 5V_SYS
	2	GPIO_GRN_HDR_R	Pull-up(330 ohm) to 5V_SB_SYS and connect to
			SIO GPIO
	3	HDD_LED_R	Hard disk active LED
	4	GPIO_YLW_HDR_R	Pull-up(330 ohm) to 5V_SB_SYS and connect to
			SIO GPIO
	5	GND	Reset button
	6	PSIN	Power Button
	7	ICH_SYS_RSTJ	ICH_SYS_RSTJ
	8	GND	Ground
	9	5V_SYS	5V_SYS
	10	KEY	Key
	11	NC	Reserved. Do not use
	12	5V_SB	LAN LED pull-up(330 ohm) to 5V_SB
	13	NC	Reserved. Do not use
	14	LAN_ACTJ	Lan active LED
Silk Screen	Footprint		Schematic Part
FP1	h2x7mzo10h85		HEADER_2X7_10

62 Chapter 5