AOC LM720BGE user manual How to Optimize the DOS-mode, Plug & Play DDC1/2B Feature

Page 12

Operating Instructions

AOC LM720BGE

 

 

DOS-mode

This feature allows you to choose between resolutions of 720 x 400 or 640 x 400 while working in DOS-mode. Follow the instructions for selecting functions in the OSD window as listed on the previous page. Press your monitor’s Power button off and then on to activate your chosen DOS-mode resolution. Note: the default DOS- mode resolution is 720x400@70Hz.

pattern has vertical stripe noise, or the characters are twisted):

1.Change the resolution to 640 x 400

2.Press the Power button off and then on.

3.Press the AUTO button for 2 seconds. Note: the above procedure must process in full-screen pattern.

To exit, press the ESC key or press ALT-F, and then press the X key.

How to Optimize the DOS-mode

1.Insert the Windows 95/98/2000/ME INF Driver Disk into your floppy drive.

2.Open Windows Explorer to search on the floppy drive (Drive A:) to find the Dos1.exe file.

3.Double-click on the Dos1.exe file.

4.Expand the picture to full screen by pressing the icon on the top of window. If there is no icon, the picture is already at full screen.

If you don't have the driver disk:

1.Choose Start / Programs / MS-DOS mode.

2.Type C:\> EDIT and press Enter. You will be in the Dos-Editor screen.

3.Press the AUTO button on the front of your monitor for 2 seconds. The screen will be automatically adjusted.

If the screen is distorted (for example: the picture can't go to full screen, the background of white

Plug & Play DDC1/2B Feature

This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host system of its identity and, depending on the level of DDC used, communicate additional information about its display capabilities. The communication channel is defined in two levels, DDC1 and DDC2B.

The DDC1 is a unidirectional data channel from the display to the host that continuously transmits EDID information. The DDC2B is a bidirectional data channel based on the I²C protocol. The host can request EDID information over the DDC2B.

AOC LM720BGE

12

v1_031004

 

Image 12
Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautions Using the Right Power Cord Special Notes on LCD MonitorsGeneral Notes Installing & Removing the Base General Features Package ContentsBefore You Operate the Monitor Connecting the Wires Using the Power Cord Supplied Before You Operate the Monitor Install An Optional Wall Mounting Arm Not supplied Adjusting the Viewing Angle How to Install INF & ICM FileOperating Instructions Front Panel ButtonsAdjusting the OSD Settings How to Optimize the DOS-mode Plug & Play DDC1/2B FeatureDOS-mode Technical Support FAQ Problem Possible SolutionError Message Possible Solution Technical Support FAQ Error MessageSpecifications AppendixEPA Energy Factory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number Description