Special Menu

Special Menu	Fine tunes and sets the special functions manually:
	ID-NUMBER （1~99 ）、INSTANT-ON 、DEGAUSS 、
	AUTO-SAVING 、AUTO DEGAUSS 、AUTO SHIFT 、
	OSD BACKGROUND、OSD CONTRAST、AND OSD H
	∕V-POSITION、MOIRE、KEY LOCK、PASSWORD.
a. ID Number	Through DM RS232 V0.9 (Serial Transmission
	Communication interface) to remote control the
	device. To identify the monitor, you must to set an ID
	number (ID=1~99) to each of the monitor under DM
	RS232 V0.9 Control page.
	1. Select the ID number (1~99) by	tab.
	2. After you set the ID, choose high/light to identify the
	monitor with has been set with a valid number. The
	monitor will correspond with the current status, and this
	could control the OSD function directly.
b. Instant-On	Enable∕Disable the INSTANT-ON. Set the INSTANT–
	ON YES, the Monitor will start up immediately while the
	Power switch on, and the green LED is lit on. The monitor
	will stay in the saving mode till the power be turn-on again
	while the INSTANT-ON is switch off, and the red LED is lit
	on.
c. Auto Saving	The power will shut down automatically and be in the
	power-saving status while the Auto Saving switch on.
e. Degauss	Enable∕Disable the AUTO DEGAUSS.
	The AUTO DEGAUSS will be executed automatically by
	every 24 hours since switch on the function.
f. Auto Shift	Active AUTO SHIFT to protect the screen from result in
	the image-remain. The picture will be auto-shift once
	every 6 hours.

g. Moiré	For some modes, it is better to switch the moiré off to get
	better video performance, and this option is provided
	when Moiré is ON, adjust MOIRE pops out, and adjust
	moiré by using ＋∕－key. In TV∕AV mode, moiré can’t
	be adjusted.
h. Key Lock	Enable∕Disable the front panel function operation.
i. Password	To release the disable front panel function operation by
	set the password.
j. OSD	Switch the OSD background ON or OFF to adapt to
Background	different software background of the PC.

Fine tunes and sets the special functions manually: