Technical Support FAQ, Lock LED, Green, Blue

TECHNICAL SUPPORT (FAQ)

Problem & Questi				Possible Solun
Power LED is not				*Check if the Power Switch is in
				position
				*Power Cord should be connec
No Plug & Pl				*Check if the PC system is Plug
				compatible
				*Check if the Video Card is Plug				& Play
				compatible
				*Check if the D-15 plug pin of Video
				Cable is be
Picture is f				*Adjust the Contrast and Brig
				Control
Picture bounces or a w				*Move electrical devices that ma
pattern is present in th				electrical interf
The power LED is ON (oran				*Computer Power Switch should b
but theres	no	video	or theno ON position.
picture.				*Computer Video Card should be snugly
				seated in its slot.
				*Make sure monitors video cable is
				properly connected to the computer.
				*Inspect monitors video cable and make
				sure none of the pins are bent.
				*Make sure computer is operational by
				hitting the CAPS LOCK key on the
				keyboard while observing the CAPS
				LOCK LED.		The LED should either
				turn ON or OFF after hitting the CAPS
				LOCK key.
Missing one of the pri				*Inspect the monitors video ca
colors (RED,	GREEN,		or	make sure that none of the pins are
BLUE)				bent
Screen image is not center *Adjust					pixel		frequency (CLOCK)
sized proper				FOCUS or press h-key (AUTO).
Picture has color d				*Adjust RGB color or select
(white does not look)				temperatur.
Horizontal	or	vertic *Use win			95/98		s-down mode Adjus
disturbances on the screen				CLOCK and FOCUS or perform hot- key
				(AUTO -key)

CLOCK (pixel frequency) controls the number of pixels scanned by one

horizontal sweep. If the frequency is not correct, the screen shows verti

stripes and the picture has not correct width.

FOCUS adjusts the phase of the pixel clock signal. With a wrong phase

adjustment the picture has horizontal disturbances in light picture.

For FOCUS and CLOCK adjustment use dot-pattern or win 95/98 shut-

down mode pattern.