AOC 712SI Controls and Connectors Video Cable, Connecting Cables AC Power Cord Sub Cable

Page 7

CONTROLS AND CONNECTORS

VIDEO CABLE

Connecting the Signal Cable:the LCD monitor comes with a built-in signal cable. Plug the signalscable15-pin connector into the computer’s VGA port and tighten the two screws on the cable connector.

Connecting the Power Cord:Connect the power cord into your LCD

monitor￿s power input socket, and then plug the other end into a 3-pin A power outlet. The power cord may be connected to either a wall power outle or the power outlet socket on your PC, depending on the type of power cord supplied with your LCD monitor.

Caution:If the AC outlet is not grounded (with three holes), install the pr grounding adapter (not supplied).

1

Figure 2 Connecting Cables

1.AC Power Cord

2.D-Sub Cable

6

Image 7
Contents Table of Contents FCC Class B Radio Frequency Interference Statement Precautions Checking the Contents of the Package Before YOU Operate the Monitor FeaturesSpecial Notes on LCD Monitors Power Cord Installation Instructions Swivel BasePower Source Page Connecting Cables AC Power Cord Sub Cable Controls and Connectors Video CableAdjusting the Viewing Angle External Controls General InstructionsMenu / Enter Front Panel Control ∙ Power Button∙ Power Indicator ∙ Auto Adjust button / ExitOSD Message HOW to Adjust a SettingEeprom Adjusting the PictureOSD Plug and Play Plug & Play DDC2B FeatureBlue Technical Support FAQLock LED GreenInput not Supported Error Message & Possible Solution Cable not ConnectedVesa DDC2B TM SpecificationsMenu Standard Resolution Horizontal Vertical Frequency Preset Display ModesRXD Connector PIN AssignmentPIN no Description TXD