RadioLAN 140 MOBILINK manual Insertiing and removiing the Mobilink

Page 10

Insertiing and removiing the MOBILINK

The transceiver comes installed on the end of the PCMCIA card, and is hinged for easy installation and safe storage after removal. The unit is designed to open at a 130-degree angle from the PCMCIA card. This allows the card to slide completely into the PCMCIA slot inside of the PC.

When using other PCMCIA devices: When the unit is open, the MOBILINK’s antenna points upward. If you use other PCMCIA devices in a second slot, consider inserting the MOBILINK into the top slot. This allows cable access to other the other card because the MOBILINK’s antenna does not cover the other card.

The PC card interfaces the transceiver with your personal computer. It slides into any Type II or Type

IIIPCMCIA slot inside your notebook. After properly installing the MOBILINK, and software drivers, you will configure the unit using RadioNET Manager.

890-01306/02/99 Version 1

Page 5

© 1999 RadioLAN. All rights reserved.

Image 10
Contents Model 140 Mobilink User Guide Notiices Diiscllaiimer Trademark Diiscllosures Manuall ConventiionsTable Of Contents Introductiion 890-01306/02/99 Version Items IInclluded with the Modell 140 Mobiiliink IInstalling the Modell 140 Mobiiliink System requirementsInsertiing and removiing the Mobilink Opening the Mobilink Inserting the Pcmcia Card Into the Slot Removiing the Mobilink Ejecting the Mobilink from the SlotInstalling RadiioLAN Driivers New Hardware Found ScreenInstall from Disk Screen Version Conflict Screen 890-01306/02/99 Version IInstalling RadiioNET Manager Range of Operatiion Range of OperationRoamiing Performiing a Siite Survey Mapiing the Site890-01306/02/99 Version Gettiing Techniicall Assiistance De Guigne Drive Sunnyvale, CA Phone 408 Fax 408