RadioLAN 140 MOBILINK manual Removiing the Mobilink, Ejecting the Mobilink from the Slot

Page 13

Removiing the MOBILINK

Always take care when removing the MOBILINK from the slot. PCMCIA slots are designed to tightly hold the card into place. There are usually ejector buttons on one end of the slot. Before attempting to remove the card, follow these important steps:

1. Press the ejector button. Pressing the button causes the unit to unplug from the internal connector, and to partially slide out of the slot.

2.Once the card has moved slightly

outward, grasp the MOBILINK on

Figure 4: Ejecting the MOBILINK from the Slot

each side, at the hinge, and then

 

pull the card free from the slot.

 

3. Fold down the transmitter for

 

storage.

 

890-01306/02/99 Version 1

Page 8

© 1999 RadioLAN. All rights reserved.

Image 13
Contents Model 140 Mobilink User Guide Notiices Diiscllaiimer Manuall Conventiions Trademark DiiscllosuresTable Of Contents Introductiion 890-01306/02/99 Version Items IInclluded with the Modell 140 Mobiiliink System requirements IInstalling the Modell 140 MobiiliinkInsertiing and removiing the Mobilink Opening the Mobilink Inserting the Pcmcia Card Into the Slot Ejecting the Mobilink from the Slot Removiing the MobilinkNew Hardware Found Screen Installing RadiioLAN DriiversInstall from Disk Screen Version Conflict Screen 890-01306/02/99 Version IInstalling RadiioNET Manager Range of Operation Range of OperatiionRoamiing Mapiing the Site Performiing a Siite Survey890-01306/02/99 Version Gettiing Techniicall Assiistance De Guigne Drive Sunnyvale, CA Phone 408 Fax 408