RadioLAN 140 MOBILINK manual System requirements, IInstalling the Modell 140 Mobiiliink

Page 9

System requirements

To use RadioNET Manager, station computers must meet or exceed the following requirements:

∙Windows 95b or later operating system

∙32Mb of RAM recommended

∙3.5 inch floppy disk drive

∙Hard disk drive with at least 1Mb of available space

IInstalling the Modell 140 MOBIILIINK

When installing the Model 140 MOBILINK for the first time, Windows displays a series of screens that guide you through a driver installation procedure. After properly installing the unit’s drivers, your PC may annunciate the presence of the PCMCIA card after the operating system boots, or when you insert the card while the PC is operating normally.

This section of the manual discusses the steps needed to install the Model 140 with the Windows operating system. Actual installation procedures may vary depending upon the version of Windows that you use, but driver installation is intuitive, and easy to perform.

890-01306/02/99 Version 1

Page 4

© 1999 RadioLAN. All rights reserved.

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Model 140 Mobilink User Guide Notiices Diiscllaiimer Manuall Conventiions Trademark DiiscllosuresTable Of Contents Introductiion 890-01306/02/99 Version Items IInclluded with the Modell 140 Mobiiliink System requirements IInstalling the Modell 140 MobiiliinkInsertiing and removiing the Mobilink Opening the Mobilink Inserting the Pcmcia Card Into the Slot Ejecting the Mobilink from the Slot Removiing the MobilinkNew Hardware Found Screen Installing RadiioLAN DriiversInstall from Disk Screen Version Conflict Screen 890-01306/02/99 Version IInstalling RadiioNET Manager Range of Operation Range of OperatiionRoamiing Mapiing the Site Performiing a Siite Survey890-01306/02/99 Version Gettiing Techniicall Assiistance De Guigne Drive Sunnyvale, CA Phone 408 Fax 408
Top Page Image Contents